Just look

Replace-fluorescent-under-cabinet-lighting-with-led, for under $200, you can replace old under cabinet kitchen lighting with energy efficient led fixtures. easy to follow step by step installation instructions. Peel and stick the leds to the under-side of the cabinet above the sink. screw the wireless touch pad’s bracket to the wall and install the switch and cover plate. disconnect the power, then plug the power back in; the touch pad should pair with the wireless dimmer. now screw the terminal to the underside of the cabinet., 5 ways to convert your fluorescent light fixtures to led. how do you replace your fluorescent tubes with led? let us count the ways! in today's blog, we break down the advantages and disadvantages of each of your options..

Under my kitchen cabinets i currently have 120 volt ac florescent lighting. i want to replace these lights with brighter led strip lighting, which typically is run using 24v dc current. the lights, there are many led under-cupboard lights that come with a driver that has just a mains lead (not a blky plug) that would wire into your existing jb. otherwise, get an led strip with an integral driver. these wire straight into the jb. for example http://www.amazon.co.uk/linkable-st...ption-powered/dp/b0060hgm7w/ref=pd_cp_light_0.

This is the oldest way of replacing fluorescent tubes with led bulbs.this option allows the user to bypass the use of a ballast circuit as the wiring passes through the line voltage instead. using this method, a commercial installation can have a high voltage of up to 277v, but, this can be dangerous if safety standards aren’t followed to the letter., i have under-cabinet lighting that's very old-school fluorescent and doesn't work great. it's flickery and some of the tubes don't come all the way on..

Replacing under cabinet lighting - posted in home automation: my house came with fluorescent under-cabinet lighting. each light was self contained with its own switch, and was hard-wired into the electrical system. i want to replace the lights with low voltage leds. my question is, when i remove the existing fluorescent lights, what should i do with the source wiring?