Just look

Log-siding-installation-instructions, log siding installation instructions the installation of meadow valley log siding requires a few simple tools; a tape measure, circular or miter saw, a chalk line, a square, and a hammer. in most cases, window and door trim is installed first, and j-blocks if applicable.. 3308 n. abbe rd. comins, mi 48619 phone: 800-818-9971 * 989-848-5408 * fax: 989-848-5535 www.woodworkersshoppe.com email: sales@woodworkersshoppe.com, put the log siding on top of the foundation log. with the hammer and wooden block, tap the tongue of lower log siding into the groove of the log siding you are installing. make sure that you tap the tongue for it to fit properly. with the hammer or nail gun, nail each side of the log siding making sure the nails are 45 degrees under the tongue..

Log siding can be easy to install with the right tools. about half of modulog installations are done by the homeowner perhaps with the help of a friend or relative while the other half doesn’t have the time or inclination and hires a local contractor to perform the work., attach the first piece of siding to the sill plate, using a construction level to maintain a straight line. screws should run through the top of the tongue, and through the groove in the bottom, and penetrate the studs at a 45 degree angle. verify that the panel is level before attaching to each stud..

Log siding starter installation for proper log cabin siding installation in a level fashion, the starter strip on the bottom of the wall must be leveled correctly. determine the lowest point of the wall that will be sided; from that point, measure up 1/4” less than the width of the starter and partially drive a nail at one corner., outlet block installation. another piece that helps with the trulog™ metal siding installation is an outlet block. an outlet block is a base and cap system that helps the siding to be accepted to your faucet, electrical outlets, and lights on your exterior walls..

Installing log cabin siding. start installing log cabin siding from the bottom and work your way to the top, using a level and/or string line. in general, 2×4, 2×6, and 2×8 trim boards should be installed prior to the log siding., welcome to everlog systems, the best way to build a log and timber home. this video is a basic introduction on installing everlog siding, which is a revolutionary engineered concrete siding product used in both renovations and new construction.