Just look

James-hardie-siding-installation-requirements, instantly access installation info, technical bulletins, sds sheets & more.. As a homeowner, you will work with a contractor, who will facilitate the installation of your james hardie® siding, trim, soffit, wrap and flashing products (including products with colorplus® technology)., ustb 17 | version 3 | page 1 of 2 for complete installation information visit www.hardieinstallation.com fastening tips for hardieplank® lap siding technical bulletin september 2014 #17 scope: this technical bulletin addresses approved fastening techniques when using hardieplank® lap siding. hardieplank® lap siding may be used with fasteners approved by icc-es esr-2290 spaced in accordance .... Com1220-p2/4 12/15 stud furring strip** batten joint installation: hardiepanel vertical siding must be joined on stud. position fasteners 3/8 in. (9.5mm) from panel edges and no closer than 2 in. (50mm) away from corners., visit jameshardiepros.com for the most recent version. tr1509_p6/9 04/18 hardietrim® boards fascia hardietrim board is a decorative non-load bearing trim product..

June 2001 jh recommends makita® #5044kb 4” or #5057kb 7-1/4” saw with dust collection.call 800-4makita. hitachi® hardiblade® w/4 pcd diamond teeth.call hitachi® at 800-546-1666 for nearest dealer. snapper shear™ electric, pneumatic, or hand shear. call 800-297-7487 for tool information., in addition to consistently demonstrating the highest standards in quality and customer satisfaction, elite preferred contractors specialize in the installation of a wide range of james hardie product profiles and designs..

Fiber cement products | james hardie pros, in addition to consistently demonstrating the highest standards in quality and customer satisfaction, elite preferred contractors specialize in the installation of a wide range of james hardie product profiles and designs.. 5. high nailing. hardie plank siding is almost always installed with air nailers, which are the best tool for quick installation. the only downside of pneumatic tools is that sometimes the installer will get going a little bit too quickly, and will lose track of where the nails are going.