Just look

Hardboard-siding-installation, before installing the hardboard siding, make sure that you seal it or use a primer on it so that all edges are covered. this is done to prevent moisture from penetrating into the siding; this is necessary because hardboards are extremely prone to rotting due to heavy moisture exposure. 2.. Install a starter strip, approximately 11/2 in. wide and the same thickness as the siding, flush with the bottom edge of the sill plate. extend the siding at least 3/4 in., but no more than 2 in., below the starter strip. nail the bottom edge of the first course of sidingù16 in. o.c. maximumùthrough the starter strip and into the sill plate., hardboard siding is inexpensive and simple to install, yielding professional-looking results for any conscientious do-it-yourselfer. you must take special care with this material prior to....

Cost can add up quickly, especially if you’re a novice and have never attempted a hardboard siding installation before. i would strongly recommend you hire a licensed and insured siding contractor to perform the installation for you., hardboard siding installation costs vary considerably by location. for an accurate estimate in your area, enter your zip code in the calculator above. reduce total project cost by having multiple vendors bid on the same, detailed work specification of your hardboard siding project..

Masonite lap siding is an inexpensive alternative to wood siding. it looks similar to wood siding, but it costs less and comes in widths up to 12 inches. often referred to as hardboard siding, masonite has received a poor reputation in recent years for lack of durability., did one story pole up from the level line, and then a second to carry up through the second floor, referenced to a course on the first floor. i can't for sure remember how i referenced the bottom -- i think maybe the pole was cut to rest on the foundation which protruded a half inch or so, though we'd make adjustments where the foundation was out of whack..

Check the siding panel for molds, holes or any damage. the siding panels nearest to the ground are usually the first to mold. remove the siding panel that is damage and install a fresh hardboard siding panel. remove the damaged siding panel using a claw hammer and extract the nails left on the wall from the old panels using tin snips., june 2001 jh recommends makita® #5044kb 4” or #5057kb 7-1/4” saw with dust collection.call 800-4makita. hitachi® hardiblade® w/4 pcd diamond teeth.call hitachi® at 800-546-1666 for nearest dealer. snapper shear™ electric, pneumatic, or hand shear. call 800-297-7487 for tool information.